Brent's Photo-Sonics Service and Spares

I have the following spares for the Photo-Sonics 1VN 16mm High Speed Camera:

Plastic Rollers, washers, and snap ring keepers
Sprockets and sprocket gears
Pulldowns and Pulldown gears
Assorted movement bearings and screws
Shutters (9, 18, 36, 72, and 120 degree)
Film Gates
Black Film Cores (Gun Cores)
Film indicator friction shafts
Take-up Friction assemblies
Pressure Plate Assemblies
C-Mount Front End Assemblies (for those tinkering folks who want to try converting their own camera)

I have the following spares for the Photo-Sonics 4ML 35mm High Speed Camera:

I can provide the following services for 1VN

Disassemble, clean, reassemble the movement/mag. If your mag is sticky, has a rough spot, or is just plain over-oiled and full of yucky black stuff...
Straighten bent registration pins (depending on the damage, this is trial and error, and sometimes they are too far gone). I have spare base parts to put your pins on (the brass colored piece that usually gets ruined in a bad jam).
Scratch Test your mag and remove any burrs.
Replace faulty power transistors
Troubleshoot INOP/Dead Cameras
Wire your camera for XLR power switches
Super 16mm Conversion for 1VN. Super-16 1VN

Give me a call for your 1VN service or parts needs. I'm very reasonable.

I also have a technician available to Rebuild 1PL, 1P, and 4ML speed control and Amplifier boards (Series 2000 or older analog).

Do you have spares you want to SELL? I Buy PARTS And Cameras.